TOPIC:

Good Morning,

I'm in the environmental testing phase. Could you help me test.

For I am newbie in this HA software.

Test 1:
Did the HA configuration using the documentation, it's all OK.

I do the following test:
I have two servers, primary and secondary. And one virtual machine.

Mando virtual machine for secondary, turn off the same, it returns the primary.

Now if it is the primary, she does not go to the secondary.

Can you help me.

Clayton

Additional information on your test scenario is needed and the messages log on the surviving server.

Are you performing a graceful shutdown or simulating a power failure?

My Scenario:

Citrix XenServer 6.5.0, we both servers.

I installed HA-Lizard as documentation, all OK.

Primary: Citrix XenServer 6.5.0

Virtual machine => connected on secondary.

Secondary: Citrix XenServer 6.5.0

When I turn off the secondary, simulating the power outage. When the virtual machine is in the secondary it goes to the primary normally.

Now when I do the opposite simulate a power outage in the primary and the virtual machine connected on it.

Does not work.

What do I do.

It's hard to tell without the messages log from the surviving host.
Can you post a snippet of the /var/log/messages log that spans the time of your test.